Wire Wound Soldered Turbulators

 

Wire Wound Turbulators

We manufacture wire wound turbulators made of loops of wire wound helically on a central rod or tube and soldered to the inner surface of the tube. The internal turbulators are made of stainless steels, copper and galvanized steel wire. We make wire wound turbulators for tubes of inner diameter as low as 8 mm. There being no limit on higher daimeters and lengths.

Wire wound turbulators are excellant tube heat transfer enhancement devices that increase the tube side heat transfer coefficient several fold at not too high pressure losses. Our turbulators are used in heat exchanger tubes used for oil coolers, compressed air coolers.

We specialize in manufacturing all stainless steel wire turbulators and other turbulators with special composition wires. Other standard material of construction of our wire tube inserts are copper, brass and galvanised steel.

wire wound soldered turbulator

TAAM engineering

B-222,MIDC, Malegaon

Sinnar, District Nashik

India 422 103

Telephone:

+91 253 6522635

+91 2551 230923

Fax:

+91 2551 230923

Mobile:

+91 9890945650

E-mail:

airheaters@gmail.com

taaming@gmail.com

Home | Root Soldered Wire Wound Fin Tubes | Spiral Tension Wound Crimped Finned Tubes | Wire Matrix Tube Inserts | Soldered Wire Loop Turbulators | Twisted Tape Tube Inserts| Steam Air Heater |Thermic Fluid Air Heater | Hot Water Air Heater | Air Cooled Oil Cooler | Air Cooled Vapor Condenser | Air to Air Heat Exchanger | Air and Gas Pre-heater | Industrial Air Cooler | Industrial Air Chiller | Process Design of Finned Tube Heat Exchanger | Improvement of Dryers and Drying System | Contact Us